Remove Rubber Grommet from Bong?

Discussion in 'Bongs, Dab Rigs, Bubblers, Water Pipes' started by carlcs3, Apr 1, 2011.

  1. #1 carlcs3, Apr 1, 2011
    I have this bong...Spiral Twist Glass Bong - Online Shop

    I am wondering if I simply removed the rubber grommet, and plugged the carb and just let the bowl sit on top of the hole, would this not work as a slider? The only difference I can imagine is the air to clear it would be like a carb rather than a conventional slider because the air would rush on top of the water, rather than rush through it and bubble.

    Thanks for helping ^-^
     
  2. #2 VToker, Apr 1, 2011
    Try it.

    The bowl on glass might not make a good enough seal though, but hey, its easy enough to put back in right?
     
  3. #3 carlcs3, Apr 1, 2011

    :) hopefully !
     
  4. #4 GORBS, Apr 1, 2011
    It wouldn't pull the smoke through the water.
    But yes, it would work.
     
  5. #5 Pliskn, Apr 1, 2011
    They tend to be there for a reason, not being a smart arse but I've tried taking them of before, just leaves a bong that's not airtight
     
  6. #6 OMGBBQBRO, Apr 2, 2011
    next time get glass on glass
     
  7. #7 TheBaron, Apr 2, 2011
    Last edited by a moderator: Apr 2, 2011
    not necessarily
    my grommeted(?) zong kicks more ass than my friends double perc tube :cool:
     
  8. #8 No1weedsmoker, Apr 2, 2011
    that will just thin out your hits, not act as a carb...
     

Share This Page