Homemade onehitter that didnt make it :(

Discussion in 'DIY and Homemade' started by AtomBong, Jun 8, 2009.

  1. #1 AtomBong, Jun 8, 2009
    so i made a little onehitter/chillum on the lathe and as i was drilling the center hole, the bit snapped off as soon as it made it through :(

    [​IMG]
    [​IMG]

    i need something strong to punch it out cause when i blow through it, a tad bit of air makes it through.
     
  2. #2 J-Darsh, Jun 8, 2009
    haha very nice
     
  3. #3 SweetMorningDew, Jun 8, 2009
    get another drill bit, and just start drilling... it will either drill through, or or push out
     
  4. #4 AtomBong, Jun 9, 2009
    tried that already. forgot to mention theres two bits stuck inside it :p
     
  5. #5 travo420, Jun 9, 2009
    how did u make that? maybe try a third bit?
     
  6. #6 aero18, Jun 9, 2009
    Nail + Hammer.
     
  7. #7 AtomBong, Jun 9, 2009
    lathe. not gonna waste my time with that again.

    already tried that too. just bent it. i need some hardened steel or something.
     
  8. #8 travo420, Jun 9, 2009
    ive got sum hardened steel;) haha sorry had to say it
     

Share This Page