Hash question

Discussion in 'Pandora's Box' started by Slater420, Sep 29, 2009.

  1. Okay so i was planning on doing this...is it a waste of time??


    step 1
    Grind up the stems, seeds, and leaves in a blender. You want to grind them finely in order for the alcohol to extract as much THC from the plant fiber as possible.
    <LI itxtvisited="1">Step 2
    Put the freshly ground marijuana into the Pyrex bowl. Pour 99 percent pure isopropyl alcohol over the marijuana until it covers it completely. You can buy this type of alcohol at any drug store. Do not use denatured alcohol, which can be poisonous and will make your hashish unsafe to use. A knowledge of basic chemistry is helpful, but not necessary. Just be careful to only allow the alcohol to come into contact with glass, because interaction with other materials, such as plastic, can be harmful.
    <LI itxtvisited="1">Step 3
    Seal the mixture in the bowl with an air-tight lid and store in a warm dry place for 24 hours. The mixture will turn green. It will turn brown if your marijuana is of poor quality.
    <LI itxtvisited="1">Step 4
    After 24 hours, poor the mixture through a coffee filter into another glass bowl. You want to squeeze out all the juices from the fiber gunk that once was your unusable stems, seeds and leaves. You will now have a greenish mixture that is just alcohol and marijuana juice, which contains all the THC.
    <LI itxtvisited="1">Step 5
    Let the alcohol evaporate from the mixture in the glass bowl. While there are methods for cooking off the alcohol on a stove in a well ventilated area, due to alcohol being flammable, these methods are dangerous and should be left to those with the proper experience and equipment. Simply place the alcohol in a clean, warm, dry area and let the alcohol evaporate naturally, which should take another 24 hours.
    <LI itxtvisited="1">Step 6
    You should be left with a green, sticky substance --- this is now the hashish. It will be difficult to use this type of hashish in a pipe because it will bubble and make a mess when introduced to flame. The easiest way is to scrape the mixture out of the bowl with a razor blade and place it on a spoon. Heat the spoon from below and inhale the smoke. Use a straw for inhaling to avoid wastefulness.


    i got all the supplies...soo im just wondering anyone else try this??
     

Share This Page