Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Gravity Bong Construction...

Discussion in 'Marijuana Consumption Q&A' started by cmoney93, Aug 12, 2013.

  1. #1 cmoney93, Aug 12, 2013
    So i have the intentions of making my own glass gravity bong. I've already put holes into my one gallon jug of wine that im using! Nest step is making the bowl...
     
    All the gb tops i've had have been passed down to me and this one will not fit!
     
    Any instructions or suggestions on how to make one?!
     
    thanks for any help

     
  2. #2 StonerNack, Aug 12, 2013
    I'll have to put mine together and take a pic for you to see tomorrow.

    It's ghetto but it works.
     
  3. #3 cmoney93, Aug 12, 2013
    i know how to make one with a pen and tin foil and piece of gum btw... but im going to attempt to make this "classy" 
     
  4. #4 BudButler, Aug 12, 2013
    you could buy a really cheep bowl or use a socket don't use tin foil thats bad
     
  5. #5 throwsomedeez, Aug 12, 2013
    Last edited by a moderator: Aug 12, 2013
    Try getting a wooden or rubber cork (the kind you find in chemistry class) that will fit in the bottle. Buy yourself a cone (or use a socket from your toolbox). Drill a hole in the cork and squeeze the cone into the hole. The hole should be smaller than the cone, so it forms an airtight seal around it automatically. You could always use plumbing sealant too (on any conepiece).

    I recommend the rubber bung option for ease of use (compared to a wooden cork that may crumble), the hardest part is drilling the hole.

     
     

Share This Page