Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

building a steamroller

Discussion in 'Seasoned Marijuana Users' started by Malenki, May 27, 2009.

  1. #1 Malenki, May 27, 2009
    So I really want to buy one, but I figure while I wait I can just make one. I am going to use the stainless steel? metal pipe from a beer keg. My question is one side of the pipe is bigger than the other, so which end of the steam roller should that be at? Bigger piece for your mouth?
     
  2. #2 schizophrenick, May 27, 2009
    I would say smaller end as the mouthpiece. That will condense the smoke into a nice thick hit.
     
  3. #3 Malenki, May 27, 2009

    Thats what i am thinking plus it has dimples on the big end like on the roor's.
     

Share This Page