Perculator/bubbler

Discussion in 'Smoking Accessories Q&A' started by disciples of Christ, Jan 30, 2016.

  1. My bong needs cleaning, and im broke lol, I wanna clean the bottom part where it seems to be trapped in the bubbler.. Is this even possible to get this resin out of that area.. I mean theres huge globs of it just stuck between the small holes.
    I seen on youtube a guy put his glass bowl in the microwave in a solo cup and got the water boiling. would this work with a bigger piece putting it in a bigger tub. I dont wanna break my piece anymore then it is. Any advice, because ive gotten everything a paper clip can get. Also broke my percs in the process



    1. Whats the best way to recover the resin without wasting it, before you go saying its bad & shit well I smoked a small ass nug of it & got scary high.. Lol a wierd but good high.
    2. Would putting it in the microwave boiling it be a yay or nay??
    Im broke, just waiting on my baby girl to start blooming. Any Ideas, I need to get stoned lol???

    You can see where the resins built up in the pic.
     

    Attached Files:

  2. Don't put it in the microwave.


    I wouldn't bother saving the resin but if you really want to go that route, I guess your best bet is going to be straight isopropyl alcohol. Highest percentage you can get. 91-99% territory. You'd have to soak it for as long as you can and then pour it on some kind of plate or dish to dry.


    But you also might not get the whole thing clean that way, second step would be isopropyl and a lot of salt. The coarser the grain the better but regular table salt is fine too. It'll act as an abrasive, so basically you'd have a sort of isopropyl and salt sludge that you'd shake vigorously until all the gunk is gone.


    But you also can't recover the resin that way.
     

Share This Page