Wire size to put on qb 96 v2 elite boards

Discussion in 'Lighting' started by Alcooner1, Oct 2, 2019.

  1. #1 Alcooner1, Oct 2, 2019
  2. #2 Catsoncannabis, Oct 2, 2019
    I used 16 guage 3 prong for the intake and 18g single solid core ( 16 works fine too, so does stranded wire ) for the outtake
     
  3. #3 Alcooner1, Oct 2, 2019
    Also if using solid core at connector can wires be taken out of connector and how

    Sent from my SM-G950U using Grasscity Forum mobile app
     
  4. #4 Catsoncannabis, Oct 2, 2019
    The part that connects to the light ? I just push them in so they are nice and tight , electrical tape around them just in case , if you want to take them out just remove tape and pull them out .I'm no electrician though
     
  5. #5 Alcooner1, Oct 2, 2019
    Thanks

    Sent from my SM-G950U using Grasscity Forum mobile app
     
  6. #6 Alcooner1, Oct 2, 2019
  7. #7 Catsoncannabis, Oct 2, 2019
    I'm not sure , on their website I think it says which driver to use for how many lights you want to run and which way you want it set up.
     
  8. #8 Sade, Oct 2, 2019
    @Tbone Shuffle would know best but I believe you only want to run two in parallel per driver.
     
  9. #9 Alcooner1, Oct 2, 2019
    Yes Tbone Shuffle has been MIA for 2 or 3 weeks

    Sent from my SM-G950U using Grasscity Forum mobile app
     
  10. #10 Soil2Coco, Oct 2, 2019
    You can run three in parallel. It will split the wattage to about 118 watts apiece


    Sent from my iPhone using Grasscity Forum
     
  11. #11 Sade, Oct 2, 2019
    Hope he is ok. He is usually quite active on the forum.
     
  12. #12 Alcooner1, Oct 2, 2019
    Yes I hope all is well with him
    He hasn't even answered a PM

    Sent from my SM-G950U using Grasscity Forum mobile app
     

Share This Page