Where is the weed doctor ?

Discussion in 'The Artist's Corner' started by Mr Magic, Mar 22, 2022.

  1. Today was a messy day.
    Had to take the hydro kit with plants out of the cabinet.

    I harvest some nice buds, give them a soak and hang them to dry.

    i check the center plant that has all wall led and is not lollipop, it is looking good.
    And there is potential from the floor up.
    It’s a bushy plant 2 ft height.
    I cut lot of leaves, and give a milky water spray, and set it to dry.

    the other two plants will start to flower soon.

    when I tried to stretch and train the new setting I broke a complete arm off with a lot of little buds forming.
    Oh shit
    Where is the weed doctor?
    I put it aside, maybe I can put it in a glass of water.

    after tying all the plants and hook up the scrog net, I decided to try to ent the piece of the flower I broke to the other lollipop plant where I amputated a low branch that I closed of with a rye rip.

    never done it before, don’t know if it works.
    The branch is thicker then the piece on the other plant.
    So I shave it and cut them both straight angle.
    Connect them with some tape.
    Hope for the best.


    so now hydro container is at low bottom
    The leds are on top height.
    Cant raise no more, it will have to do.
    3-4 weeks to go for the next harvest.
    24 hours led on and a clean grow room.

    couple of nice bud to dry, and I already have a earlier cut that I can smoke this week.
    All good
     

    Attached Files:

    • Like Like x 1
  2. Plants self repair much like you and I do. Reconnect the ends, Splint and bandage. :)

    BNW
     
    • Like Like x 1
  3. I hope so, it is another plant that I connect it to.
    That has no flower yet.

    so new experiment for me.
     
  4. So branch broke off of one plant and attaching it to a different plant? Is the same strain or completely different? I'm interested to see either way. Taking notes.

    Sent from my BE2028 using Grasscity Forum mobile app
     
  5. Yes, a low branch from one plant to a stump from another.
    The branch is in flower, the new plant is not.
    Both plants are the same seed.
    Fem. Autoflower.
    24h light

    will it work ?
     
  6. Oh I have no idea but it seems like it's worth a shot, what other options do you have?

    Sent from my BE2028 using Grasscity Forum mobile app
     
    • Like Like x 1
  7. Now that is one I haven't tried. The branch should survive but just what it'll do is a good question. Continue in flower? Reveg? Some half ass in-between state?

    BNW
     
    • Agree Agree x 1
  8. For sure, I'm intrigued.

    Sent from my BE2028 using Grasscity Forum mobile app
     
  9. Nope that did not work.

    i was gone couple days, when I arrived back home the experiment failed.
    All my bad offcourse. The stump was to dry and I did not cut it right.
    Better luck next time.

    the weed that was in the dry box was rock hard dry, left it couple of days in a jar.
    And smoking today. Like it nice and soft smoke.

    the other plant is in flower good, and is ready to bulk up.
    15 holes in the screen are with decent flower.
    The lower part looks good as well. And starts to ripen a bit.

    the other plant is not in flower yet, maybe it is not an autoflower, I guess I will see coming weeks.

    the other group of four is going to fast.
    And it’s a little jungle in the pre grow.
    I had only one side element so the other side is climbing over the other one.

    and the three lowryder are one week old now.
    And show happy leaves.
    So I have to decide what to do soon.

    the flower cabinet takes too long, and the rest is out of control soon.
    I will have to make outside plants from a couple.
    Otherwise I can’t manage it.
    Very happy that the weather is getting better here. And i can move some outside.

    i want to finish all these plants, and then go to Hawaii.
    When I come back I have my smoke ready.
     

    Attached Files:

Share This Page