Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

what to clean my pipe with and how to keep the smell at a low level

Discussion in 'Apprentice Marijuana Consumption' started by caliking4, Jan 23, 2010.

  1. #1 caliking4, Jan 23, 2010
    i usually hide my weed in some cloths but i just got a new pipe and i dont wanna keep it in my car cause of the smell and i wanna keep it smell free what can i do? ... and yes i know my pipe looks like a girls lol
     

    Attached Files:

  2. #2 AlchemicalDependence, Jan 23, 2010
    I wouldn't worry about the smell so much, but to clean it with minimal smell, put some rubbing alcohol and table salt in a ziploc bag and shake it around a bit
     
  3. #3 RepentYeNbelievethegospel, Jan 23, 2010
    NO,
    just read this: http://forum.grasscity.com/toking-tools/235580-official-piece-cleaning-guide.html

    To sum it up,
    run hot water(from the tap) through your pipe for a minute or two. Now put it into a small ziplock bag, pout about 1-2 tablespoons of salt in there, and pour rubbbing alcohol(highest % you can find) in until its submerged if it were in the corner of the bag.
    Seal it and roll down the top a few times, get a good grip and SHAKE it like hell for 5 minutes total, when you see its completly clean-
    Remove the piece and rinse it THOROUGHLY because alcohol is flammable, not to mention the taste is terrible. Rinse with warm/hot water at least 10 times.

    Note: Never ever EVER use soap or detergent on smoking devices.
     

Share This Page