I know only the very basics of it all but want to make some with all my trimmings.. What all do I need to be able to make wax? I know a vaccum, butane, and some tubes or something? Haha sorry I am a total n00b on this.. I just want to know what I need to be able to MAKE the wax and then I will learn how to make it thanks!
You put your trim, stuff it into the tube. Glass preferably. Out your coffee filter of the open end of the tube ok. Tie it with a rubber band or what not. Take the proper size adjustment from the lid of the butane can to fit properly into the small hole of your tube. Put the piece on the end of the can of butane and spray about a full can to a can and a half depending on how big the tube is through the weed. The buane will chill the thc and freeze it all through the microns of the filter. Do this over a glass Pyrex dish to collect all of the liquid butane. Very careful not to expose the vapor to any source of heat or open flame as it is very flamaable. Once you have "ran" the butane into the Pyrex get some water boiling and set your Pyrex 1/2 inch deep in hot/very hot water. This will "purge" the liquid butane out of the oil that will remainin the glass as a sticky substance. I have been taught to purge for up to 3 hours. 30 minutes being standard. And the longer the purge the more pure the oil. You want to purge in the hot water bath until there are NO bubbles. Once that is done throw the Pyrex onto the lowest setting of the oven you have. For about 15 minutes "whipping" back and forth with your dabber once or twice every few minutes. And wala you have fresh made bho no vaccume needed! I have done this and sold the product to many happy people. Tuckerjonesisreal
But to answer the ? A tube (glass) 50-100 micron organic coffee filters Rubber bands Weed 12X12 Pyrex dish. Butane (cans) Stove. Dabber Wax paper I bought one of those giant sticky pads from the smoke shop that nothing sticks to and did my whole run on top of it. Tuckerjonesisreal