Grasscity - Cyber Week Sale - up to 50% Discount
Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Water in Bubbler?

Discussion in 'Marijuana Consumption Q&A' started by BearThug, Jan 9, 2013.

  1. #1 BearThug, Jan 9, 2013
    http://i.imgur.com/VCr2O.jpg

    How much water should I put into this? The bowl where the weed goes, there is a downstem looking thing that goes 3/4 of the pipe downwards.. Should I fill this up with water just so that it touches the little downstem looking thing?
     
  2. #2 SwichOne, Jan 9, 2013
    [​IMG]
     
  3. #3 Stormy Sea, Jan 9, 2013
    Last edited: Jan 9, 2013
    Genuine question. Could easily be googled, but still a genuine question.

    Should fill it up until it rises above/covers the tip of the end of the downstem, perhaps a centimeter more.

    Remember that search engines are your friends :)
     
  4. #4 BearThug, Jan 9, 2013
    I know this sounds like a dumb question, but I just noticed that when I don't put as much water the bubbler doesn't really make the bubbling sound... So was wondering if it would be ok to just fill it up to the trip tip...
     
  5. #5 Stormy Sea, Jan 9, 2013

    No.. too much water will cause wet hits and bong water in your face. Nasty nasty. Also more easily tippable. Less is usually more.
     
  6. #6 Dontlickthat, Jan 9, 2013
    Have one just like that with different design! Fill the water up until the downstem is submerged about 1-2cm.

    Sherlock bubs like that hit well! Unfortunately a friend broke mine today :(
    He's replacing it with a nice hammer bub though
     
  7. #7 The innovator, Jan 9, 2013
    YO that's my exact bubbler just in different colors! What I do is fill it up til water comes out of the carb then tilt it like 45 degrees so a bit of water comes out and you are good to go.
     
  8. #8 *guest, Jan 9, 2013


    Yep, too much water will cause your bowl to get wet.

    What you should do, is fill it up (while the bowl is empty) to just barely above the downstem. Stick your finger just barely against the bowl hole while carbed (don't press too hard, you don't want to restrict airflow) and suck.

    Keep adding more water until you feel like you have the appropriate amount of bubbling going on, but without feeling any water hit your finger that is in the bowl.

    Ta-da! :smoking:
     

Share This Page