Hey can someone help me make this holland vodka bong, it sounded pretty bad ass and I wanted to try it out, but I dont know anything I need to make it, all I have is the bud and the bottle lol, can someone tell me what I need and instructions how? Preciate it!
You need a glass drill bit and a drill, if you dont have those just go buy the bong its like $40 somewhere. Otherwise insert drill bit into drill Mark where you want the slide to go in Put drill on the drill gear symbol not the numbers Start drilling while not pressing too hard and only go half speed with the drill Keep the drill bit straight or youll crack where your drilling the hole clean glass shards out with warm water/rubbing alcohol. Buy one of those rubber O ring things to put in between the glass and down stem insert slider Make sure you know the downstem measurement. Say its 43 mm you might want a 45 mm drill bit. Just make sure your measurements are correct or look up a tutorial on YouTube.
Exactly. Also, if you're looking for the parts, the drill bit you need is a carbide drill bit. Cheap at home depot/ace hardware. And the ring thing you need is a grommet. They cost like twenty-five cents. Also, it helps a lot to take a needle pick and scratch an "X" (small) where you want to drill, and rubbing a bit of wax on the spot (cheap candles work just fine) will help keep the bit from slipping and keep the glass from heating up in that spot and shattering your bottle. Also, wash the piss out of the bottle after you drill but before you smoke... you do NOT want to inhale powdered glass.
[quote name='"Javarius Reptar"']Eh, what will you use for the downstem? A pen? That's not going to last forever.. Buy a bong![/quote] The point of this was for him to make his own bong. You can buy metal downstems and sliders or glass ones, its not like only pre-made bongs come with them. I want to do the same thing after seeing that vodka bottle.
a Dremel works quite a bit better than a drill. spins at much higher speeds. A diamond bit also works for drilling through glass. Having 2 people is also a good idea one to hold the piece an squirt water where you are drilling. Will help keep glass dust down. Also recommend you do it outdoors and wear safety glasses.