Discussion in 'Grow Room Design/Setup' started by Rp7r, Oct 12, 2014.

  1. #1 Rp7r, Oct 12, 2014
    Last edited by a moderator: Oct 12, 2014
    Hello all,
    I have moved my set up in the interest of stealth into the walk in closet in the top right of the picture. It is a condo and on the other side of that is the hallway. 
    I have a 4x4 tent in there for flower and a small veg/clone/mother area next to it. Right no I have a fan pull air from the 2 600watt lights in the tent and push it into the bottom right corner of my room. My temperatures are getting up to 32.5 degrees with the lights on and I dont know a good way to ventilate this. 
    Any help would be appreciated.
    Also, I am looking to add another 15 amp circuit to the breaker in the room in the top centre. My breaker box is full so I would have to install a sub box and move some circuits over. Any ideas on a good way to do this and route the power the new room?


    Attached Files:

    • 3D.jpg
      File size:
      63.9 KB
  2. #2 Rp7r, Oct 12, 2014
    Last edited by a moderator: Oct 12, 2014
    i will post flower room when it is on

    Attached Files:

  3. You don't necessarily have to add a sub panel unless you main breaker is maxed out you could always get a two in one breaker as far as getting the wire to that closet you would have to find the easiest path to reach the grow op attic or crawl space? But being a condo I'm sure that there are other units above and or below?

Share This Page