Used epoxy gorilla glue to fix my bubbler, is it safe to use?

Discussion in 'Bongs, Dab Rigs, Bubblers, Water Pipes' started by Ampl, May 17, 2011.

  1. #1 Ampl, May 17, 2011
    Last edited by a moderator: May 17, 2011
    I used some gorilla glue to fix the mouth part of my bubbler.

    [​IMG]
    [​IMG]


    But I got some on the inside by accident.
    [​IMG]
    [​IMG]



    Will it be safe to use or will there be smoke fumes coming out of the glue even though the smoke goes through 2 chambers?
     
  2. #2 nuclearbong, May 17, 2011
    Probably not safe. I think that glue would melt and you would be inhaling fumes.
    I like that piece though. Sucks that it broke.
     
  3. #3 Electus Unus, May 17, 2011
    so long as its 100% dry already, and you dont torch the glue you'll be fine.
     
  4. #4 LetsGeek, May 17, 2011
    Its going through the water already so it should be fine for small amounts but I would invest in another piece dude. Sorry about your luck
     
  5. #5 Ampl, May 17, 2011
    Yeah it sucks. I broke it on friday the 13th >__> . It was 50 dollars but I'll give it a shot. If something does not taste/feel right then I'll do away with it, maybe give it to someone who wants it.
     
  6. #6 deletemenowplz, May 17, 2011
    no way, it's no where close to any part of the piece that is heated. you should be fine.
     
  7. #7 illadelphia1990, May 17, 2011
    You should be fine.
     

Share This Page