Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

trouble Bongin' it up

Discussion in 'Apprentice Marijuana Consumption' started by dc123, Mar 13, 2010.

  1. Alright I have a bong my brother gave me and I have used it about 4 times. I don't know what it is but I just can't get really good hits on it. I want the milk, thick white smoke hits but I can't seem to get them. What am i doing wrong?

    Also, sometimes I'll go to clear the tube and i will have already sucked in all the smoke anyways. What the fuck? Am i doing something wrong or is that ok?

    Thanks GC

    :yay::bongin::bongin::bongin::bongin::bongin::bongin::bongin::bongin::bolt::hide::poke::gc_rocks:
     
  2. If there's a carb you should try plugging it with your thumb if you havent already.
     
  3. Plug the carb is all I can think.
     
  4. Air through the female end? I snapped off my female part on one of my old bongs days ago and it wasn't 100% air tight so it wouldn't chalk it up.
     
  5. Try pulling through the tube slower and the smoke won't spread out through the tube so fast and it will stay nice and white.
     
  6. if its one of those rubber grommet bongs, the little stem attached to the bowl is really thin and can get clogged, check and make sure there's no resin/ash buildup in there by taking a safety pin and scraping around in there a bit. I had that problem where hardly any smoke would be in the tube and after I cleaned out all the crap that was in there, it works well now
     

Share This Page