Hello, GC! So, I have two Active Aqua 1/10 HP Water chillers. I have three DWC buckets, however. I haven't been able to have 3 plants going full blast in the hotter months, and would really like to get it going. I do not have the juice or room to acclimate a 3rd water chiller. I was thinking "splicing" one of the chillers between two 5 gallon DWC Buckets. I would just get another pump for the 3rd bucket. ( ), I would get a couple Y-connectors 1/2 inch in size (), and hook them up to the tubing that goes in and out of the chiller. So each "spout" on the chiller would have an inch of tubing that goes into the Y-connector that would then have 2 tubes, each of the tubes going into one of the 5 gallon buckets. (1 "in" and 1 "out" tube per bucket) Is there a reason this would not work? I'm a little concerned about the water flow going into the chiller, from two tubes into the spout. Would this damage my chiller from too much pressure?
