Some input needed

Discussion in 'Grow Room Design/Setup' started by Xeroes, May 26, 2010.

  1. Alright i'm working on a two chamber cab one on top of the other, but having a little trouble figuring out how to vent the air from both chambers out the same exhaust port while eliminating light leaks between the two. I'm tryin to minimize the amount of ducting as well to save space. I'm wanting to use and inline fan like one in the pic below from home depot but im concerned about how quit they are because stealth is the key after all :D

  2. You said you was going to use a inline fan at the end of it?And these light leaks so to speak.Are the from where the two pieces come together?
  3. I would not use a home depot fan. I have looked at them. Can be very loud and wont suck a lot of the air out you will need. Go with a HO inline fan. Check online at places like HTG and HID hut.
  4. I would use a Y to go from the fane and the Y part to go to each chamber and seal the unions with Duct tape..Yeah I guess I have poor man

Share This Page