Shortened male 14mm joint snapped off...

Discussion in 'Bongs, Dab Rigs, Bubblers, Water Pipes' started by Alldayeryday, Aug 13, 2012.

  1. on a electroformed piece of mine. A little bit under a quarter of a normal male 14mm joint is left. What can I use to reconstruct the rest of the joint, at least enough to have a dome or a curve on their sturdily without releasing anything bad because the hot metal will be on it? It's fully electroformed so I can't get another one blown on it... :p
     
  2. How do so many bad things happen to your glass?
     
  3. I have terrible luck in general dude (this wasn't me again, twas a cat or wind that knocked over a lamp into it)
     

Share This Page