She will RESPECT MY AUTHORITAH!!!!

Just thought I would show some pics of my version of LST, More tops the better right?

Gota train the BEOOCHES!

How is she looking?

 

I had to nurse her back to health after she got sick as a seedling(MG soil and Quench problems)

I almost lost her but with alot of tlc & transplanting a few times she's made an outstanding comeback.

I just tied down a few more tops and in about 2 weeks I will be going to 12/12.

She was on 24/0 just switched to 18/6 2 more weeks to let the lower growth sites on the newly LST branches start skyward then 12/12 to flower.

I have had some bad luck at cloning her only got 1 out of 10 (Thats why i vegged so long to, to let her recover with new growth)

But here is a few history pics and she is about 2 1/2 months old.






topped












Tied down the 2 main branches from topped plant




new growth after clones taken






I'LL TAKE A FEW MORE PICS TONIGHT AND POST FOR THE CURRENT lst'D BRANCHES

 

After a rough starts the clone s taking off to be the new mom!

 

Next Generation.

Although I hope they're female, I am leaning on wanting 1 male to seed 1 nug of the momma plant

 

Isn't she though, I am very happy with my momma plant

I got her from seed from a conec that slings and he said it was a sativa, outstanding (mind ripping) buds but minimal yield, using a lst variation and keeping her compact (no stretch) I hope to prove him wrong on the qty.

Also want to cross her with one of those holland seed plants I started wich are taking off after a rough start themselves.

Earlier I used fishing line, now just thread, it does not take much to bend her a little this was and that, I do not intend to drop her to ground level, just bending branches a bit to alow undergrowth to take off.

The tread is tied to a hole in the pot, the other end is loose, just put through a hole and a push pin to keep the very slight tension. It is so much easier this way cause if I want to bend a little more I just loosen the pin a tad and pull the sting then push the pin tight, 2 seconds and its done!

 

I use alot of perlite and it's just the perlite getting a little cooked from a 400 watt MH/HPS but now with the jumbo fan in there i get 75 % door open, 86 deg closed

 

75 % Ment to say 75 degrees

 

She's drinkin alot of watter now!

 

Well momma here was looking down and out and most of the lower branches have reached the same height as the mains so I decided to release the lst lines and let her go! She perked right up!






Clones a comin!