Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

poking a hole in your waterfall bong

Discussion in 'Apprentice Marijuana Consumption' started by MadDroIngo, Sep 21, 2008.

  1. #1 MadDroIngo, Sep 21, 2008
    I have no access to a drill or anything, i made a waterfall bong but when i treid to poke a hole it wouldnt go through, what should i use
     
  2. #2 ChrisSmokes, Sep 21, 2008
    If you're just using plastic you can use a lighter to make a crappy hole or a light cig for a better looking one.. but if you're using glass idk what would be strong enough to make a clean hole..
     
  3. #3 NOTaPIE, Sep 21, 2008
    if it's plastic you could use a lighter to heat up the plastic then jab it with something for the hole.
     

Share This Page