So today i made a percolating gravity bong. How i made it is the following, First i got a normal waterbottle and a socket. Put the socket in the cap through heat and scissors. Then instead of just making a gravity bong i cut all the way around where the top of the label is. Then I cut the bottom of the water bottle off. I sealed these two together through super glue and duct tape. Then i got a hollow pen and cut it in half. i connected the bottom of the socket to the pen making it part of the cap...You see what im getting at? THEN i got a Canadian Dry bottle and i cut 1/4 off it leaving the bottom and cutting the cap off, I sealed these two bottles together till they were air tight via duct tape. So now i just had one problem. How to get smoke from chamber 1 to chamber 2. So what i got was a hollowed out pen (again) and I used heat to make it melt and i formed it the way i needed i put the top of the pen right below the cap of chamber 1 and i connected it to chamber 2. then i cut the bottom of the canadian dry off. How it works is pretty simple. Water goes down the downstem is filtered out through the water and through the tube to chamber 2 where smoke gathers.
i hope you realise everyone reading this is gonna be high, so u need pictures or something bcuz reading is not fun bro.