I was wondering if this would make the blunt/joint smoke better. First pic is a normal joint, the smoke has to take a wonky path around all the little bits of weed, could be a really hard draw if you roll tight First pic would be sliding a needle through the center, once pulled out it will be creating a straighter "tube" for the smoke to go through Last pic is hopefully the smoke taking a much easier path which should = really easy draw What do you guys think
to much effort, little pay off ill keep my J's original although the concept works if you roll out a small sheet of hash and roll it into a tube and light one end til it smoulders, and you have a hash joint.
I would say grind it fine and moisten it with a couple drops of water. and pack it in. my joints cherry till the end. and burn slowly
I don't think it would make much of a different, truthfully. neat concept though. if you rolled the joint/blunt really, really tightly then did this, it would probably improve that. but I'd rather just roll something of a nice tightness than go through the trouble.