Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

My first bong - help

Discussion in 'Apprentice Marijuana Consumption' started by Nykoo, Feb 16, 2010.

  1. #1 Nykoo, Feb 16, 2010
    Just got my first bong yesterday and a grinder with a keif catcher. I smoked for like a year smoking mostly blunts and joints. Anyways I have some questions because i never owned any kind of glass piece before.

    How and what do i clean my bong with(my bong is all glass)?

    How much is that little screener for the bong slide and do i need one?



    Thank you
     
  2. #2 struckwithfear, Feb 16, 2010
    Rubbing alcohol and salt works wonders when cleaning glass.
    and screens are like 5 cents, get a few you'll probably need them unless yours has a built in screen.
     
  3. #3 Nykoo, Feb 16, 2010

    nice, what kind of alcohol does it have to be and will cleaning it a lot not harm it?
     
  4. #4 ganjaplant, Feb 16, 2010
    iso, or boiling water with salt
     
  5. #5 struckwithfear, Feb 16, 2010
    any kind of rubbing alcohol will work. add some salt in with it and figure out the best technique to clean it. its perfectly safe, just make sure you rinse it well before use.
     
  6. #6 Nykoo, Feb 16, 2010
    also im not sure if my bong has an ice catcher or not lol my bro put ice but it fell, i was thinking u have to put bigger ice cubes and not the square ones?
     
  7. #7 ganjaplant, Feb 16, 2010
    If it had ice notches there would be little notches in the bong so an ice cube couldn't fall down. I'm assuming its not an ice bong since the cubes fell through.
     
  8. #8 PENDEJADA, Feb 16, 2010
    If it fits in a pot, boil it to loosen up the gunk and then do what has been suggested. If it's a straight tube it should be easy but if it has ice catchers or whatever... and all that other mess it'll prob. be a pain in the ass.
     

Share This Page