Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Is it safe?

Discussion in 'Apprentice Marijuana Consumption' started by MacMillerPA, Jan 28, 2011.

  1. #1 MacMillerPA, Jan 28, 2011
    Can i seal a home made bong with hot glue?
     
  2. #2 kouchlockOG, Jan 28, 2011
    I dont think so. Im sure there are chemicals n shit in it. Unless you are putting it on a spot that isnt going to get hot.
     
  3. #3 Monteepython, Jan 28, 2011
    Hey fuck, that's a great idea.
    Thanks eh =D


    I don't think it would be too bad.
    But my home made consists of a
    Big clear-plastic OJ container
    Down Stem and an ash catcher :)

    The part getting hot would be the AC, so no. Not bad in this case.
     
  4. #4 MacMillerPA, Jan 28, 2011

    yeah yeah im not , they wont get hot at all, i just was making sure
     
  5. #5 Conegirl, Jan 28, 2011
    head to a gardening store and buy some liquid cellulose, it dries up and turns to glue when its heated up. it's from plants so no nasty chemicals
     
  6. #6 RipIt1, Jan 28, 2011
    You're Mac Miller. Buy some glass.

    :laughing:
     
  7. #7 kouchlockOG, Jan 28, 2011
    I didnt know that. Someone knows her shit :smoke: Thanks for that tip. I like making homemade pieces sometimes and will probably use that.
     
  8. #8 MacMillerPA, Jan 28, 2011

    Ohhhh sweet thanks!
     
  9. #9 Conegirl, Jan 28, 2011
    If you go to the effort you can build pieces entirely out of it
     

Share This Page