Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

How To Fill Up A Recycler Bong?

Discussion in 'Apprentice Marijuana Consumption' started by sinc799, May 12, 2014.

  1. If you really need to ask that question, then I suggest you stay in school brotha.
     
  2. I'm just not sure how high to put the water. I know you put it in the part where the nail goes.
     
  3. #4 dankness420, May 12, 2014
    Last edited by a moderator: May 12, 2014
    Well I have not hit that specific piece, I would pour water in, test it, pour water out, test it, fill to desired level and take some dabs.
     
    I would start with about 115mL of water and go from there.
     
  4. Just a little bit above that hole...like a bong man lol

    Sent from my EVO using Grasscity Forum mobile app
     
  5. #6 4shotmark, May 12, 2014
    Last edited by a moderator: May 12, 2014
    I have an Anodyne. I love it. Travis Baird is a chill dude.

    Anyways, just pour the water directly in the male fixed stem. Pull on it as you add the water to make sure you add enough for the recycler to function properly.

    Enjoy your Anodyne.
     
  6. Thank you this was the exact answer I was looking for.
     
  7. I have an 18.8 custom and it's almost impossible to overfill. Such good function. You're gonna like your piece man.
     
  8. every peice nd person likes it differmnt. i like to fill my recycler a good amount where it recycles perfectly but not more then i need to put. 
     

Share This Page