1. Dismiss Notice
  2. Dismiss Notice
Update About Advertising on Grasscity Important: A New Chapter for Grasscity
Dismiss Notice
Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

How do I clean my pipe to smoke the resin??

Discussion in 'Experienced Cannabis Enthusiasts' started by bellee, May 22, 2005.

  1. #1 bellee, May 22, 2005
    I don't think I've ever need to scrap/clean a pipe to smoke the resin. In my younger years I use to roll all my roaches into a joint and smoke that. Me and hubby have been out for 3 days and I'm a gettin' crabby :( Anyone have any tips on how to scrap my pipe/bowl??
     
  2. #2 IceCreamKidd, May 22, 2005
    We usually straighten out a paper clip and scrape it around inside emptying it out on a piece of paper or small plate. Something stiff, but slightly bendable works best, somethings that can work in the crannies and get the sticky icky resin out. :)
     
  3. #3 bellee, May 22, 2005
    Ooo, paper clip! Thanks :)
     
  4. #4 dirtybongwater, May 22, 2005
  5. #5 Garcia76, May 22, 2005
    if its full of resin just straight hit the piece youll get a nice huge hit. mmmmmm i think im gonna smoke some resin now cause nobody seems to have any ganja.
     
  6. #6 mietoe, May 22, 2005
    the best ever i think is go buy the cheapest nail care kit from walmart, and it will have 3-5 different scrapers, they work excellent!!!!! every time.
     
  7. #7 mietoe, May 22, 2005
    ooo and when halloween comes again, some of the smaller knives in the pumplikin carving kits are also good, hehe.
     
  8. #8 bellee, May 22, 2005
  9. #9 bellee, May 22, 2005
    Thanks again for all the helpful hints guys, they worked like a charm :D
     
  10. #10 TheHempress, May 22, 2005
    We use tweezers that are meant for electronics. They're thin and sharp, and they do the trick. It works best if you heat the bowl a bit first to soften the resin up a little.
     

Share This Page