HookednCookeds DIY carbon filter *micro*

Discussion in 'Micro Grows' started by hookedNcooked, Oct 11, 2014.

  1. #1 hookedNcooked, Oct 11, 2014
    Last edited by a moderator: Oct 12, 2014
    Hey guys!
    So after sitting down and doing a lot of research I finally found out a quick and easy way to make a carbon filter for micro grows. I tried making a couple carbon filters but, they all restricted too much airflow causing my temps to rise and cause too much stress on my PC fan. This is quick cheap and easy! Around $10-$12.
    Items needed:
    Atrium grate (found at homedepot or any hardware store) I'm using a 4" I have a 120 mm fan they have 3" 4" and 6"
    One or two zipties (I got the adjustable ones just Incase I need to change anything)
    Activated carbon (found at any pet store)
    Single legging (the cheap kind make sure it's very breathable)
    Scissors ( to cut the zipties etc..)
    Foil tape or ducting (to mount it)

    Ok so let's get started....

    Take out all your things

    Now take your atrium grate and stick it inside the stocking like so..
    ImageUploadedByGrasscity Forum1413058731.773521.jpg



    Take your zipties and tie it just underneath the lip and then trim
    ImageUploadedByGrasscity Forum1413058749.575053.jpg ImageUploadedByGrasscity Forum1413058762.195632.jpg

    Now pull the stocking back over the grate like this..
    ImageUploadedByGrasscity Forum1413058823.848700.jpg

    Take your carbon and pour it inside of the stocking. Mind you.. You may add whatever amount of carbon you want for veg I suggest 10 oz for flower 18 oz. Pour the carbon in slowly stop move it around then pour more in, you kind of have to work it in a little bit to form its shape. Pour in till you have an even layer of about a 1/2 inch.
    ImageUploadedByGrasscity Forum1413059042.968083.jpg

    After you pour your carbon in take the top of the stocking and pull it as tight as you can get it so it doesn't sag and so it can keep its shape. ImageUploadedByGrasscity Forum1413059205.196929.jpg

    Tie the stocking into a knot then trim..
    Voila! Your done! Use your foil tape or whatever you prefer to mount it to your fan!



    Sent from my iPhone using Grasscity Forum
     
    • Like Like x 1
  2. Yea sorry forgot to post the pic of trimming also here's what the inside looks like..
    ImageUploadedByGrasscity Forum1413059619.867145.jpg ImageUploadedByGrasscity Forum1413059629.182790.jpg


    Sent from my iPhone using Grasscity Forum
     
    • Like Like x 1
  3. Good thing you asked it took me like a half hour to find it after having to go through about 5 employees!
    It's all the way in the garden section where I was it was the garden section outside all the way in the back.


    Sent from my iPhone using Grasscity Forum
     
    • Like Like x 1

Share This Page