1. Dismiss Notice
  2. Dismiss Notice
Update About Advertising on Grasscity Important: A New Chapter for Grasscity

Homemade Glass

Discussion in 'DIY Cannabis Gear & Homemade Smoking Tools' started by Viewtifreak, Jun 2, 2009.

  1. #1 Viewtifreak, Jun 2, 2009
    I am looking to make some home made glass but didn't know what to buy dremel-wise. Canadian Tire had this [​IMG]


    It's like 30 bucks, is there anything else I'd need to drill into a vase or bottle? And sorry about those italics I hit a key and didn't know how to fix it.
     
  2. #2 pyro44199, Jun 2, 2009
    just go very very slow and don't put pressure on it
     
  3. #3 Viewtifreak, Jun 2, 2009
    Thanks for the tip, but I mean are there any more parts for that thing I need to buy, or do I just use this as is?
     
  4. #4 Boston092, Jun 3, 2009
    get a glass drilling bit aswell
     
  5. #5 Snare214, Jun 3, 2009
    i think i might look into getting one two, because honestly there isnt a week that goes by that i dont see a piece of glass and think to myself "wow that would make a great bong"
     
  6. #6 ganjapolice, Jun 3, 2009

    ha ha me too
     
  7. #7 Viewtifreak, Jun 3, 2009
    Last edited by a moderator: Jun 3, 2009
    [​IMG]
    So that's what I've done so far, this was just to test the rotary tool out. And the tool only cost me 10 bucks. The angle of the bowl is shit obviously, but it's a glass bowl attached to a metal pen, the top of which screws off making the bowl detachable and eliminating the need for a carb (it was just a tester so I didn't care about making a slide)
     

Share This Page