Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Homemade bong?

Discussion in 'Marijuana Consumption Q&A' started by Herbalist90, Jul 30, 2012.

  1. Im planning on making a little 'pocket' bong tonight. I have a little plastic bottle, about 10 cm in height and 5 cm in width, if a burn a little hole in it and slot in a little socket for a bowl? Would this work if i placed the weed the the bowl and inhaled whilst lighting it?

    Thanks :smoke::smoke:
     
  2. put some tin foil into it or something to act as a filter and yea your good
    try to make a little carb too
     
  3. burn a hole about the size of a 1euro coin just under the spout of the bottle take the foil out of a cigarette box prick a few holes in it with a pin stick the foil into the hole and push it down in to the inside of the bottle leaving some sticking out around the edges of the hole flatten this down on to the bottle or u can stick it with tape if you like but it stays put with out tape then burn another hole down the very end of the bottle to put your mouth over and one more smaller hole also at the bottom but on the opposite side of the bottle to put your finger over while sucking the smoke. put your weed in the foil and voila! takes less than 5 mins to make!
     
  4. Glass works better and is easier to use...
     
  5. If you don't have a glass piece, then yeah the small plastic bottle works
     
  6. Just go with a gravity bong. It can be portable also. Can give more specifics.
     

Share This Page