Homemade bong help again

Discussion in 'DIY and Homemade' started by ryannelson, Feb 13, 2009.

  1. What's the best way to seal joints on a homemade bong made from a plastic bottle, pen tubes, and a socket from a wrench. Hot glue? I'm just trying to get it to rip good. little drag and jank. Any help would be much appreciated.
     
  2. just use electrical tape and melt it with your lighter, that's what I always do
     
  3. you should try your best to find a tapered pen so you can burn the hole the same size as the small end of the pen and stick it in there then let the plastic harden again and shove the pen tub in as far as you can and you'll get a sick suction when you hit, but just burn a rush hole wherever you're trying to hold your thumb
     
  4. but seriously if you're gonna take the time to do that you might as well make a lightbulb vape, much more worthwhile
     

Share This Page