Home made Bong Problem. help

Discussion in 'DIY and Homemade' started by Sattelight897, Jan 19, 2010.

  1. i'm trying to make a bong but i cant get the stem to go in at and angle. it keeps going sideways. Any suggestions?
     
  2. Make the hole an oval like a zero; 0 and less like a; o.
     
  3. glue it up. the 0 wont help unless you actually use something to keep it in that position.
    this happened to me once as I put down a homemade bong, i heard the water creep up the steam and soak all my bud
    tsssssss

    most depressing sound other than a bong breaking you ever will hear.
     
  4. if you have a hot glue gun, USE IT!
     
  5. Just tape it then unless you have something like hot glue.
     
  6. melt the hole with a lighter and when it is about the size of the stem, when its just a tad smaller, it will still be hot then you shove it threw at the angle u want and hold it there
     
  7. i have some superglue but i heard that you shouldn't use any gule because of the fumes
     
  8. Was the hole for the stem drilled at an angle? It's difficult to do, but it is loads easier in the end to drill the hole at an angle. Also, are you sure everything is the right size?
     
  9. i didn't make the hole at an angle. also not sure if the size is right. i'll look in to it
     

Share This Page