Last week I bought a nice new bong for 60 bucks, nothing special but its a pretty big nice cool colorful bong and I bought a 40 dollar ash catcher to go with it. This thing rips awesome and I love it but yesterday, like I always I am an idiot and knocked it over. The top of the female piece broke and the rest of the bong and the ash catcher are fine. My girlfriend and I continued to smoke it after filing the glass down a little bit because now the glass ends right at the rubber piece and it works pretty well. My gf ripped it another time and... no bubbles. I looked inside and the rest of the female piece broke off. When this broke off the edges are very workable to repair it. There is still a tiny bit of the female piece inside the rubber part which I am guessing would be best to clean that out first. So basically, can anyone tell me what the best way to repair the rest of my female piece well back into my bong would be with some basic household appliances. Gorrilla and krazy glue usually work well but I dont wanna take any chances. If I can get the piece to stay in the right place than the bong should work. Please anyone!!!
Post a pic or drawi g of this Cause from your story it sounds lime the jount where you slide the downstem into broke, i have had this same problem before but usesed tape and now she still works like a charm
url=http://www.flickr.com/photos/41195443@N03/5399103518/][/url] 1 by Muller12, on Flickr 4 by Muller12, on Flickr 2 by Muller12, on Flickr 3 by Muller12, on Flickr 5 by Muller12, on Flickr Here ya go and thank you
You could do that but I am doing a quick fix. I filed the broken end down pretty well and when I stick it in the bong with the rubber piece it goes down far enough. I am just going to glue it to the rubber piece probably but what should I use, Krazy glue, Gorilla glue, or a good adhesive glue I have?