Great Waterfall Bong

If your like me and don't like to use harmful materials like aluminum for making your homemade paraphernalia this waterfall is for you. It may take a little time to make but it's worth it.

What you need:
1 Wine Bottle
1 Apple
A knife
A nail
A hammer
A candle/a lighter you don't mind wasting
a thick needle


How to make it:

1) Get your wine bottle and center the bottom of your wine bottle over the candle's flame without touching it. Hold it there for about a minute.

2) Immediately after heating you are going to chisel/hammer a hole into the center of the concave bottom. This is best done by either having a friend hold the bottle while you gently hammer the nail or pinning the wine bottle down on a table or other surface so that is cannot move. You may have to heat it twice before you finally make the hole.

3) Now that you have a hole in the bottom heat it up again(not quite as long) and gently chisel the hole to the size you want it. Remember the small the hole the slower the water flows out and thus the denser the smoke will be. Plug up the bottom with your finger and test out how the water flows. If you made the hole well enough the water should flow out in a single stream and not spider web on the bottom.

4) Now for the bowl. Instead of plastic or aluminum we will be using an apple. This part is a little tricky but not too difficult. Get your apple and cut a third of it off. When i say a third i mean cut it on its side so that the stem of it is not included. it should be about 2 inches thick at its center.

5) Then, take your third and press the center of the inside of it on top of the wine bottle so that you have a good outline of the rim of the bottle.

6) Next, cut out this cylindrical center following the inner ring of the outline. It should be about the size of a cork although it should not fit quite as tight or else the holes you poke will squeeze shut so its best to cut it a little big and then whittle it down to fit well.

7) You will now carve a bowl shape in the soft inner of your apple cork. This is the top of the bowl where your bud will go. Then poke holes all the way through and suck and blow and see if you can cleanly draw breath through the apple cork.

8) Last, test everything out. Put your apple cork inside making sure it doesn't slip in because you won't be able to get it out. blow into the bottle and breath in making sure the holes weren't sealed.

9) Your Wine Waterfall bong is now finished. Fill it with water and plug up the bottom hole with your finger or something you can remove. Place your apple bowl into the rim, and then your herb in the apple. remove whatever stopping the bottom and spark your bowl. As the water flows out your wine bottle will fill with smoke. Remove the bowl and suck in with the bottom hole now acting as a carb.


I know this may be a little difficult to understand but if you do understand you should definitely try it. As far as i know i am the inventor and so far only person to make this exactly as it is.
Happy Toking