Gorilla Grow Tent Setup Questions

Discussion in 'Grow Room Design/Setup' started by Colorado N00b, Aug 27, 2014.

  1. #1 Colorado N00b, Aug 27, 2014
    Last edited by a moderator: Aug 28, 2014
    I have been doing a lot of reading and am getting ready to start purchasing everything I need to start my first grow. Before I start spending I just wanted to get some input if any of this is overkill or a waste of money and how it will work out.
     
     
    4x4 gorilla grow tent 3x3 Scrog inside will be the actual grow footprint
     
    600 watt mh/hps digital ballast/air cooled hood with a 6in vortex fan pushing air through duct to hood to duct out of tent exhausting out a basement window.
     
    6x16 phresh carbon filter at top of tent air being pulled through filter by 6in vortex fan exhausting out basement window.
     
    3-4 5 gallon RDWC buckets with a control bucket outside tent with a water cooler outside tent circulating water from control bucket through cooler back to control bucket. A 25 gallon PH adjusted reservoir on float valve.
     
    a constant monitoring temperature/ppm/ph monitor for the hydro set up.
     
    2x 6 in passive intake at bottom of tent opposite side of tent from exhaust with a filtered light trap outside tent.
     
    both fans will be on fan controllers to adjust speeds
     
    obviously the nutes circulation fans timers ect.
     
     
    This will be set up in a colorado basement with ambient temps of 65-70 year round.
     
    appreciate any feedback.

     

Share This Page