Dismiss Notice
Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Glass glue.

Discussion in 'Cannabis Consumption Q&A & Tips' started by Timotonx, Sep 14, 2012.

  1. #1 Timotonx, Sep 14, 2012
    Is there a better, more solid glue for glass than epoxy? Cuz it's the 3rd time my ashcatcher breaks by itself... :(
     
  2. #2 smokin bud, Sep 14, 2012
    If its the third time the same ash catcher broke, i think its time for a new ash catcher.
     
  3. #3 frogsaver, Sep 14, 2012
    Holdup, you can epoxy your broken glass together?!? I broke my ashcatcher but it was pretty minimal, just the top when I out the slide in so it wouldn't really be holding any water or much smoke
     
  4. #4 Suby Dude, Feb 17, 2015
    i recently broke my dab rig, right where the nail sits on the stem/joint, thought about using some epoxy to fix, since i only paid $50 for the thing from a friend. but I'm mostly worried about the heat creating fumes from the epoxy and inhaling them, any ideas or suggestions?
     
  5. #5 waldoe420, Feb 17, 2015
    I would stay away from glue/epoxy on anything that would be exposed to heat. 
     
  6. #6 Bonghoots4lyfe, Feb 17, 2015
    My bubbler broke and I found this stuff to work really good.
    Wouldn't put it near the bowl though
     

    Attached Files:

Share This Page