ok, well, as some of you know, during the last few days, i haven't had my bong or bowl, due to them being confiscated. but, i have quickly and easily replaced my bong. i've developed the best bong i've ever smoked out of, and all the supplies didn't cost me a godamn thing. allright, i will guide you through the steps and procedures to make this bong. -what you will need- -plastic bottle(any size) -1 meter of garden hose, or any rubber/plastic tube -one of those white masks that people where over their faces when spray painting, the things that are kinda like a coffee filter that you where on you're face -something sharp(scissors, razor, knife, sword, axe, spear, etc.) -LOTS OF DUCT TAPE ok before we get started, the final result of this bong should be similar to a gas mask from like a dentist's office or something. sure the thing can't even touch the beauty of a nice glass bong, but those motherfuckers are spendy, and this bong isn't, and in my opinion, this bong is far superior to any 200 dollar bong. now, i have no idea hom much these supplies would cost you, seeing as i stole mine from my habitat for humanity station this morning. so if you have no cash, just find an ungaurded construction site. Step 1- take the filter mask thing, and cover both sides with duct tape so that you get little to none oxygen when you inhale. (note-this is probably the hardest longest most time consuming part of the whole ordeal) Step 2- cut a hole that the hose will fit into, but don't cut a hole too big, you should have to force it in there, the hole should be in the middle of the mask, right in front of you're mouth, don't have the hose stick too far out into the mask so it'll be comfortable, then, duct tape the hose to the mask. now you should have the gas mask deal going. Step 3- with the bottle you have cut a hole like the one in the mask in the top of the bottle, not the upper half of the bottle but the actual top, or cap if you will, slide the hose in how ever far you wish, i recommend having a couple inches in the bottle just for support. duct tape once again. make sure you can remove the cap though. Step 4- cut another hole for the hose in the bottle, do this in th middle of the bottle. (IMPORTANT-make sure that you put the hole on the opposite side of where you will be while wearing the mask) but the hose in, for this part you don't need much of the hose, duct tape. Step 5- take some tin foil, put it on the end of the hose sticking out of the bottle, form the tinfoil into a bowl for putting the weed in. take a safety pin and poke a bunch of little holes in it. (note-tin foil is probably the best substitute for screens) Step 6- FINAL STEP, place weed in bowl, strap mask around your head, light, take as many deep breaths as you want. P.S. use water with this bong, DUH! and a choke is not mandatory, allthough i prefer one, i assume i don't have to teach you how to put a hole in a bottle. enjoy, and give me some feedback yo! peace.
i am also working on many other projects much like this one, when i finish them all, you will know about it.