DIY NFT Mini Cloner

Discussion in 'Hydroponic Growing' started by Hydrogeeks, Apr 9, 2016.

  1. The design incorporates one 10gal tote nested within a 19gal tote, and a 15gal aquarium filter system. A hole for the intake pipe is made in the 10gal, as well as one in the center for the drain. Be sure to make both holes the same diameter as the intake pipe. The bottom tote must be filled with 15gal of water for the system to operate properly, which makes it very heavy, so be sure it's in a final, steady location before filling it up.


    Sent from my 0PJA2 using Grasscity Forum mobile app

Share This Page