Parts needed: 8 x 10" reducer duct piece. $6 at hd Duct tape $2.50 10" fan $5 at a goodwill there $15 new @ hd Tools: Razor blade Philips screwdriver Drill with 1/4 bit Sharpe Beer 1# find the cover for the Philip screws on the sides. 2# Pull off screw cover and unscrew the two philips screws. One on each side. 3# cut some of the fins off on the back of the fan that restrict airflow. 4# Aline the fan on the ducting reducer and mark where you need to drill on each side. Remove fan. Drill a hole on each side. 5# Turn the fan on highest setting. 6# Put the fan in the ducting reducer and screw in the fan with the factory screws. 7# Duct tape the reducer and fan for a good seal. 8# Drink beer
i've been getting extremely discouraged over spending money after my blower crapped out until i saw this! making one tomorrow!!