Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Burnin

Discussion in 'Apprentice Marijuana Consumption' started by Applegarth, Jan 14, 2009.

  1. #1 Applegarth, Jan 14, 2009
    So I want to make a massive pipe out of like a coke bottle( it should be fun ) but I was wondering, I can burn a carb hole really good but when comes time to burn where the bowl would go It just blows up and melts too fast, so should I cut out the bowl hole then?

    or other suggestions?
     
  2. #2 WakeNBakeN420, Jan 14, 2009
    Cut it out or drill it out. Search youtube im sure u can find a vid on how to make one:)
     
  3. #3 greenerdeaner, Jan 14, 2009
    Cut a hole and use gum to hot glue for a strong seal

    or spend $10 and get a plastic water pipe from a shop
     
  4. #4 stickydankness, Jan 14, 2009
    a pipe out of a coke bottle? dude thats lame...go buy a cheap glass spoon for like 20 bucks at a headshop, it will rip way harder than shitty coke bottle...
     
  5. #5 abilities, Jan 15, 2009
    i hope youre talking about a glass bottle...
     

Share This Page