Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Building A Bong

Discussion in 'Marijuana Consumption Q&A' started by forty9erfan, Oct 2, 2014.

  1. So I'm making a bong out of a jack daniels bottle; this is my first time making my own bong. I'm going to buy a 5/8" diamond head drill bit for like $10 and probs just buy http://www.bongoutlet.ca/downstem-14mm-14mm-p-648.html this downstem and I already have a bowl piece to fit it. Do you guys think that the rubber part of the downstem will be enough to seal the gap between the downstem and bong itself? If not, what would be the best way to seal it?

     

Share This Page