Broken straight tube base Help

Discussion in 'Bongs, Dab Rigs, Bubblers, Water Pipes' started by Dvent, Feb 21, 2015.

  1. Using this helix piece for awhile now and someone just set it down to hard I guess and the based cracked down a little . What is my best bet for it to look nice without getting it blown . Still holds all water .Trying for it not to look ghetto either tho ImageUploadedByGrasscity Forum1424493851.742946.jpg


    Sent from my iPhone using Grasscity Forum
     
  2. jb weld works wonders  you can even get it clear i think or like if your good with clay i know a few people who have made bases like that
     
  3. What can I do so no shards are sticking all over the place make it smooth again iv seen 2in rubber bases online for cheap


    Sent from my iPhone using Grasscity Forum
     
  4. Throw it away its garbage now ball for a new piece... Glue and shit gonna look hillbilly
     
  5. Still functions and does its job 100% like it was when blown that's why I can't just toss her
     
  6. #6 WILLIAM SMOKES BONGS, Feb 21, 2015
    Last edited by a moderator: Feb 21, 2015
    Ok..
     
  7. Break it off, find a nice wooden kinda plaque like base thing, carve out an area to fit the broken part of bong, glue er down
     

Share This Page