Broken Bong Help

Discussion in 'Bongs, Dab Rigs, Bubblers, Water Pipes' started by Bindin13, Oct 22, 2011.

  1. #1 Bindin13, Oct 22, 2011
    So went to a party...brought my bong and it broke. The bowl cracked, and the entire upper half of the down stem is snapped off. Nothing on the main part of the bong is cracked or anything though. I was wondering whats the best solution for this?

    I can't get the bottom half of the down stem out. I'm thinking about just buying a new bowl and it should just fit in where it broke. Thoughts?

    [​IMG]

    Broken
    [​IMG]
     
  2. #2 HBGBUB, Oct 22, 2011
    Gotta get the downstem out and get a new bowl don't be a douche and not fix the downstem. You already were a douche for bringing your bong to a party don't exacerbate it by being cheap and not fixing your shit properly
     
  3. #3 Bindin13, Oct 22, 2011
    Last edited by a moderator: Oct 22, 2011


    I'm being a douche? :confused:

    That down stem is stuck inside, there is nothing to even pull it out with. If I just break the end of that broken glass, sand it down maybe, and throw in a nice bowl the diffused down stem should still be working. ?? :smoke:
     
  4. #4 theglasscouch, Oct 22, 2011
    just do some surgery hardcore you might have to get creative...
     
  5. #5 HBGBUB, Oct 22, 2011
    [quote name='"Bindin13"']

    I'm being a douche? :confused:

    That down stem is stuck inside, there is nothing to even pull it out with. If I just break the end of that broken glass, sand it down maybe, and throw in a nice bowl the diffused down stem should still be working. ?? :smoke:[/quote]

    I didn't say you are a douche o said you were a douche by bringing your bong to a party. That's just asking for some kind of trouble. That would work you might need a 14mm bowl now instead of 18 but it might. The joints may not match up properly though. Good luck whatever you do.
     
  6. #6 BlankIT, Oct 22, 2011
    looks like a 14mm so i'm going to tell you to do the same thing i did. I had a 14" roor.de minimaster and the ds broke the same exact way, take a #2 pencil eraser side and gently push and twist until it gets stuck into the downstem, heat the joint up, lube it up, do whatever precaution you want to do, then pull it out as hard as you can, but STILL be careful with your glass,not sure how thick your joint is. - ben
     
  7. #7 imnickim, Oct 22, 2011
    use a toothpick. that tiny bit of glass sticking out at the top is wat ur gonna have to work with. cover it with something so u dont cut urself and just twist it all over. iv also let soap drip into the sides of it and that somewhat worked i think

    ps.. now u know y u were the only person that had a bong at the party
     

Share This Page