Any ideas to fix this?

Discussion in 'Bongs, Dab Rigs, Bubblers, Water Pipes' started by NotRufio, Feb 5, 2013.

  1. #1 NotRufio, Feb 5, 2013
    imgur: the simple image sharer

    This is Nightcrawler. 2 feet tall, double dome perc.

    I broke him at the... stemhole(?) while moving my arms too much after a frustrating phone call with the girlfriend. I still have the piece that broke off. Think if I got something like modeling clay I could just reform it with that?

    I'd love any ideas you guys can think of cause this guy hits like Goku.
     
  2. #2 WhereDaTreeAt, Feb 5, 2013
    When you put the downstem in does it still work?

    That is a dope ass bong you have there by the way.
     
  3. #3 NotRufio, Feb 5, 2013
    Nah, the opening is a little too wide now, can't get a pull.
     
  4. #4 WhereDaTreeAt, Feb 5, 2013
    Last edited by a moderator: Feb 5, 2013
    Man that's shitty. Since that part doesn't really get hot, do you think it'd be possible to super glue it?

    It'd be a damn shame to lose that beautiful piece of glass.
     
  5. #5 NotRufio, Feb 5, 2013
    I got some glass on glass glue, hoping it works.
     
  6. #6 smokers, Feb 6, 2013
    My bong broke just like that and I just smoothened both ends down and duck taped the shit out if it and it worked perfectly. Very ugly and ghetto... but it worked.
     
  7. #7 guest0934092, Feb 6, 2013
    You can use quicksteel. Its like a clay so you can mold it to fit perfectly

    Dr. J
     
  8. #8 tobymac420, Feb 6, 2013
    Yea I used quicksteel to fix a piece and it worked nice.
     
  9. #9 NotRufio, Feb 7, 2013
    Self-Fusing silicone tape was wrapped around it. Holding it in place very well. Thanks for the tips. I'll have to try quicksteel on a more broken piece.
     
  10. #10 Shmev, Feb 7, 2013
    am I just super high or does the angle of the joint look whack as hell?
     

Share This Page