Separate names with a comma.
You should always hang CFLs horizontally. Much more light comes out of the sides of the bulb than the bottom due to the thickness of the glass.....
You should really only be cutting leaves that arent doing the plant any good. The flower sites themselves dont really need alot of light, as they...
Yeah aluminum foil is shit. and it will retain more heat than mylar. But a good gloss white paint will reflect up to around 85% The nicest...
Nah, decent dryer vent ducting will do you fine. You can get unsulated ones if youre really worried about it, but as long as the ducting is sealed...
I had one of my light ballasts in my shop melted so I need to replace it, I can take some pics as I'm wiring it up so you can get the basic idea....
Yes, you need to properly ground the device. That is why you were shocked touching the heatsink, because the unit could not get a good ground...
Just dont shock yourself. Its perfectly safe if wired properly.
Technically it is amps that kill. But amps are "pulled" by the object, volts are "pushed" from the power source, and theyre both interconnected...
So Ive got the cabinet basically built minus securing the door. Right now I just lay the board against the opening, but I'll pick up some hinges...
For a 3ftx2ft room, I would follow along the lines of the recommendations above. If you end up going with an HPS ballast, a single 600w or...
Nice. You could drill tiny little pin holes all the way around that PVC frame, then install a threaded T-fitting somewhere and thread in a remote...
Actually nevermind that post. I just received my seeds today hidden in an old blackberry case. I even took that purple blackberry case to my local...
I made a 40gbp purchase on april 22 that I havent received a notification that it has shipped yet. If I make an additional 10gbp purchase, can I...
Damn, I need to start building and selling tents. I could make that same tent for under $100, and they charge over $500...
Nice. Everyone on here recommends flat white paint for walls and I'm not sure why. Actually I am sure why, they think the flat white is less...
Looks like youve got it worked out pretty well. Its a good starting point anyway. You can just go with that, and run it for a little while and...
Measure the OD of the bars, and go to your local hardware store. In a pinch, go to the plumbing section and look at the cpvc elbows. Theyre...
Which makes it cheaper per sq ft than all but the absolute cheapest of paints....
With your dimensions I think you should leave it at 4 plants max in flower room. Even if theyre young clones (like 2 weeks or less) you will still...
Sounds like a good basic setup. 1/2" ply might be easier to work with than 3/4" mdf. Just as strong, and similar price... Unless you already...