Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Boiling Water To Clean A Bong?

Discussion in 'Apprentice Marijuana Consumption' started by Br4dley, Feb 24, 2011.

  1. #1 Br4dley, Feb 24, 2011
    Hey GC, bongs lookin a lil dirty but i dont have a kit or the right fluid, was just wonderin if boiling water would work? if i just ran it through it?
     
  2. #2 Piller, Feb 24, 2011
    c-c-c-c-c-craacck!
     
  3. #3 blowindown, Feb 24, 2011
    Fill it up with some 91% or 99% Isopropyl alcohol and let it sit for a bit.
     
  4. #4 Br4dley, Feb 24, 2011
    it wont crack cos its acrylic
     
  5. #5 jointroller, Feb 24, 2011
    NO!

    it will leave the resin stuck forever.
     
  6. #6 blowindown, Feb 24, 2011
    Oh, no isopropyl then. It'll ruin it. Just use hot water. Not sure about boiling temp, though.
     
  7. #7 grease, Feb 28, 2011
    I do it all the time and it works amazing get rid of all resin in less then five minutes. and dont worry about glass cracking unless you have really shitty chinese glass
     
  8. #8 blowindown, Feb 28, 2011

    Read through before you post. He has an acrylic bong, not glass. :rolleyes:
     

Share This Page