Jump to content

The Grasscity Magazine Launch

Your new #1 Marijuana Resource, check it out and Disqus(!) Grasscity Magazine, share the love blades!


how hot do bic lighters get?

  • by BackCatalogue
  • Oct 07 2005 01:13 AM
  • 5 Replies
  • Please log in to reply
  • Registered User

  • PipPipPip
  • BackCatalogue
  • Registered Upgraded
  • 84 posts

Posted 07 October 2005 - 01:13 AM

does anyone know the temperature of a bic lighter?
Replies (5)

  • Spreading The Word

  • MrBubbles
  • Old School
  • 1,068 posts

Posted 07 October 2005 - 02:15 AM

no, but why do you want to know?

  • Registered User

  • PipPipPip
  • BackCatalogue
  • Registered Upgraded
  • 84 posts

Posted 07 October 2005 - 02:19 AM

im really bored so im gonna make a bong and use apoxi to glue it together and on the package it says do not put under 225 degreees

  • Old School Stoner

  • Zeppelin Joint
  • Old School
  • 992 posts

Posted 07 October 2005 - 02:29 AM

well the direct flame would be over that but as a sealent arround the stem going into the chamber i'd be supprised if it got to over 100 degrees at the sealent while torching a few salvia bowls with a propane torch. the bowl would get friggen hot im guessing 300-600 max but the stem wouldn't really get past 100.


you can buy silicon for cheap and some silicon is specificly formulated to hold strength at high temperatures. People use silicon to give a perfect seal where the gasket touches the metal on an engine when rebuilding so it resists heat well and can hold in the pressures from an engine while heated up as hot as a performance engine heats up.

aslong as that glue isn't directly toughing the bowl it'll be ok.

  • Registered User

  • PipPipPip
  • BackCatalogue
  • Registered Upgraded
  • 84 posts

Posted 07 October 2005 - 02:51 AM

well im drilling a hole in a trippy lookin vase

and i was just going to apoxi the stem to the vase and have a carb because i dont know how to make a female. can you buy silicone glue?

  • Spreading The Word

  • MrBubbles
  • Old School
  • 1,068 posts

Posted 07 October 2005 - 05:12 AM

for the slide you could just use a small metal pipe, one that fits your stem.




1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users

© Copyright 1999 - 2015 420Network BV | All rights reserved