Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Need help on how to roll a joint

Discussion in 'Apprentice Marijuana Consumption' started by Blue23, Nov 22, 2015.

  1. #1 Blue23, Nov 22, 2015
    Ok l know it's a topic on how to roll a joint but when I roll one its to lose and pieces of the weed falls out. When I roll a blunt it's happen to but a least I can get some what tight. Any help would be greatly appreciated

     
  2. #2 Buzz God, Nov 22, 2015
    Try rolling with a filter tip. That way weed won't fall out of one end and that solves half of your problem. Plus you get smoother, better hits imo [​IMG]
     
  3. #3 NoMidZone, Nov 22, 2015
    hi.
    [​IMG]
     
    • Agree Agree x 1
  4. #4 wafdof, Nov 22, 2015
    Look on YouTube. Not sure why but seeing it makes all the difference in the world to me.
     
  5. #5 Superpurpleskunk, Nov 23, 2015
    Last edited by a moderator: Nov 23, 2015
    Take a rolling paper and fold the bottom to right under the glue strip, then crease. Now, you spread .5 to .7 of ground weed in the crease.
    [​IMG]



    Now, with your thumbs and index fingers, rub the two sides of paper together and downwards to form the weed into the shape of the joint.


    Next, tuck one end of paper into either the left side or right side, whichever is more comfortable for you, i prefer to tuck the right corner. Keep tucking and rolling the joint till its rolled up flush with the glue strip. Lick the glue strip and roll up to seal.
    [​IMG]



    If its a little loose, then take a pencil or something and pack in one end of the joint, then twist the paper and tear when your ready to smoke it.
    [​IMG]

    Don't worry about spilling some weed, when you try to do it too perfect sometimes it can be a lot harder. Roll your joints over a table or something so that when you do spill some weed, it will be easy to clean up and put back in the grinder.
     
  6. #6 That One Stoner, Nov 24, 2015
    Try rolling a blunt. All you do is tuck that shit, slobber on it, and then pull it over with your lip to seal it. Or buy a joint roller until you can roll. Theyre like $3
     
  7. #7 Moonwalker, Nov 28, 2015
    dude look up a guide to roll joints with a dollar bill. I never had to learn it but it's great for beginners
     
  8. #8 Amiram, Oct 21, 2020
    This is less than a minute video on how to roll a joint, very useful!
     
  9. #9 Frostbite6969, Oct 21, 2020
    Just pinch the ends :) should keep all your flower inside the paper . A filter helps as well.
     
  10. #10 rainfall34, Oct 25, 2020
    Last edited: Oct 25, 2020
    These videos pretty much taught me how to roll a joint. When I first started rolling joints, they came out like crap. But as you gain more experience, and as long as you have the right tools, your joints will come out a lot better.



    HOW TO ROLL A JOINT!!! - The Weedtube

    And I recommend these videos for learning how to light a joint and prevent canoeing of the joint.




    And you'll need to learn how to remove the child safety off a Bic lighter so it's easier to use and doesn't hurt your thumb.
    https://www.youtube.com/watch?v=qkhQ1KwqyT0
     

Share This Page