Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Question on concealing synthetic urine for drug screen

Discussion in 'Apprentice Marijuana Consumption' started by HimynameisMattyK, Oct 20, 2015.

  1. #1 HimynameisMattyK, Oct 20, 2015
    I'm not sure if this is the right part of the forum as I looked through all the sub forums and didn't find anything. This is the first time I've ever had to use synthetic urine so I'm very nervous. I just want to know if anyone can give a specific answer as far as the best way to conceal it. I'm concerned that rubber banding the hand warmers to the bottle and then tying it to my leg will keep it too warm. What do i use to tie it to my leg? Is it okay to go without the warmers and just microwave for 10 seconds and tie it to myself? Any help would be much appreciated!

    Sent from my SM-P600 using Tapatalk
     
  2. #2 KensingtonKush, Oct 21, 2015
    Get a hard bottle not a water bottle. Water bottles make too much noise. Put on compression shorts put it on the inside of your thigh then put on baggy pants like sweat pants
     
    • Like Like x 1
  3. #3 growboxhero12, Oct 21, 2015
    Spandex briefs I was just talking about this earlier and the kit comes with a bottle an hot hands and has a temp meter on the bottle that way when u get in the bathroom pull it out and if it's too hot stall for a minute blow on the bottle or pour it in the cup an blow it however but if temps are off you are dead in the water
     
    • Like Like x 1
  4. #4 HimynameisMattyK, Oct 21, 2015
    I did the test today. I ended up putting the bottle between my leg and groin to keep it warm. Once I gave the specimen, it was around 94 degrees. I hope this works!

    Sent from my SAMSUNG-SM-N900A using Tapatalk
     
  5. #5 wafdof, Oct 22, 2015
    When you pour it make sure you make a loud ahhhhhh sound too. It really takes the testers out.
     

Share This Page