Hey guys! So I am half way through an engine swap on my 2001 subaru forester. So I blew a rod through block! So now I am in the process of an engine swap :/ So I have pulled the accessories off and have gotten the engine out. Now I am planning on getting a ej251 short block and putting my current heads on that.
Just put some super glue to seal out dirt. Burns a little but goes away. Sent from my iPhone using Tapatalk
I checked them with a level and I think they are fine. the heads were just machied about 6 months ago
have you thought about a ej22 swap to avoid the head gasket issue with the 2.5? Might not be enough power for the heavier forester tho I guess
Drop one of these in and be done with it You'll have to shove over 20lbs of boost in it before you toss a rod