Food and Drug Administration (FDA) Disclosure:

The statements in this forum have not been evaluated by the Food and Drug Administration and are generated by non-professional writers. Any products described are not intended to diagnose, treat, cure, or prevent any disease.

Website Disclosure:

This forum contains general information about diet, health and nutrition. The information is not advice and is not a substitute for advice from a healthcare professional.

Water level on bongs with percs

Discussion in 'Apprentice Marijuana Consumption' started by Kayla_, Mar 6, 2015.

  1. #1 Kayla_, Mar 6, 2015
    This is not my bong but the percs in my bong look exactly like that though. Can't take a pic at the moment phones dead so found something close to what I've got. No honeycomb just one set of percs that look exactly like they do in the blue bong pic. I'm new to bongs with percs and was wondering how much water do i put in the percs part and do i still gotta put water in the bottom of my bong that's apart from the percs. Because i wasn't 100% sure if i put water in the percs are that i still needed to put water in the main part of the bong through the slide part. I have a slide bong with one set of percs about 7 or of them. Just need to know the right water level. Thanks guys.

     

    Attached Files:

  2. #2 Flight96, Mar 6, 2015
    You wanna put water in both the main part of your bong and where the percs are.
     
    Fill them up with water just above the final slit. Every slit in the percs should be submerged in water. 
     
    Keep in mind that a lot of people tilt their bong when they go to take a hit, so you may want to add a little bit of extra water so that when the bong does get tilted, each perc slit is still submerged in water.
     
  3. #3 Southeast stoner, Mar 6, 2015
    +1 :smoke:


    -Appreciate what you got cause one day it can all be gone-
     

Share This Page